Impressive Info About How To Build Cantenna

So how does the cantenna work?

How to build cantenna. Step one drill a 12mm in the side of the all metal can for the n connector. Method 1 creating a simple antenna download article 1 strip the insulation off the end of a coaxial cable to create a simple antenna. In this clip, learn how to make a cantenna.

Our measurements are based on a 100mm. A cantenna is a high powered wifi antenna that can be used with any computer or device that is made out of an. Just a vid of how to assemble a cantenna to increase the range of your wifi adapter.

Drill ruler ideally a tripod 1. Use this handy calculator to figure out where to place. In this post i will show you how to diy a cantenna for your wifi network.

5.5 ghz cantenna as a feed horn. Here is a photo of the finished wifi cantenna: Yagi or parabolic antennaes are the most effective at concentrating the power of the wifi transmitter in a specific direction but they are complex to design and construct.

You can purchase everything in a cantenna kit on ebay for around 25 bucks,. Step two insert and solder a 30.7mm (1/4 lo) piece of 12 gauge wire. Inside the tube is a 1/4 wave radiator positioned 1/4 wave away from the rear of the antenna.

The cantenna is an abbreviation of the word. Get a coaxial cable that’s long. The key part is the can.

In front of the radiator, the tube is approximately 3/4 wave long. Typically my approach to projects is that they need to be. In order to simplify the construction process and make it easy to construct locally, a cantenna design was chosen.

Build a high gain wifi antenna out of a soup can how to: The waveguide antenna is a relatively simple principle.